How to Save and Sync notes to ENData

🔄Once a project has been synced to ENData, you can save and sync your notes seamlessly. When you type a note on a job, you can choose to save it in Loop Logic only, or save and sync it so it also updates ENData.

Steps:

Open the job you want to add a note to and go to the Notes section.
Type your note into the New Note field.

At the bottom of the note, choose one of two options:
Save: stores the note in Loop Logics only.
Save & Sync: updates both Loop Logics and ENData.

Once saved, you can identify a synced note because it will show Synced with ENData underneath it. A regular note saved with Save alone will not show this label.

These notes don't notify anyone directly, but when saved with Save & Sync, they are recorded in ENData as general updates.

FAQ

What's the difference between Save and Save & Sync? Save stores the note in Loop Logics only. Save & Sync stores the note in Loop Logics and also updates ENData.

How can I tell if a note has been synced to ENData? A synced note will show "Synced with ENData" underneath it. Notes saved with Save alone won't have this label.

Does saving and syncing a note notify anyone? No, these notes don't send a notification to anyone. They're recorded in ENData as general updates.

Can I sync notes on any job? This applies to projects that have been synced to ENData.

❓ Need Help

If you have questions or need assistance, use the chat box in the bottom-right corner to contact the Loop Logics support team or email support@looplogics.com